真実試験のNetwork Appliance NS0-509試験問題、練習で知識点を暗記する

下記はNetwork Appliance NS0-509試験問題集は実際の試験問題のバージョンの一部です。 Network Appliance NCIE-SAN Specialist Certification NS0-509問題集は実際の試験問題バージョンには89問になります。すべての実際の試験問題は、勉強者が最初の試みで成功することを保証できます。NS0-509問題集の実際の試験問題でNetwork Appliance試験に不合格になった場合、全額で支払い手数料の払い戻しを受けられます。実際の試験問題をトレーニングしたいでしょうか？では、トレーニングしましょう！

NS0-509フルバージョンを入手

問題#1

Exhibit.

You are adding a boot LUN for a new server. The server uses FCP attached through a CNA. The ONTAP cluster is also attached to the same fabric by way of UTA2. You configure the zoning for the fabric as shown in the exhibit. You discover that the server cannot see its boot LUN.
What is the problem with your zoning configuration?
A. The zone set must have the same name as the zone.
B. The zone was not activated.
C. The zone used a wrong zone ID.
D. The WWPN for the NetApp LIF is incorrect.

A. D

問題#2

You are provisioning a LUN using an ISCSI initiator on an ESX host. You disable Ethernet flow control for all ports but are experiencing
Performance issues.
In this scenario, which two actions would improve the performance issue? (Choose two.)

A. Set the MTU settings 1500 for optimal performance.

B. Dedicate your ports to ISCSI traffic.

C. Enable jumbo frames across the entire data path.

D. Confirm that your host .mil storage polls are connected to a different network.

問題#3

A customer wants to use both Cisco FC and FCoE switches in their ONTAP environment. According to NetApp best practices, what are two requirements in this scenario? (Choose two.)

A. You must use single initiator zoning.

B. You must create interface groups to isolate FC and FCoE LIFs.

C. You must create a trunk with multiple virtual LANs.

D. You must not have more than one target UF for the same physical port in a single fabric zone.

問題#4

Exhibit.

The VMware ESX host discovers only two of four paths to a LUN on a new ONTAP cluster.
Referring to the exhibit, which statement Is correct?

A. The fabric zoning configuration does not allow access to the target LlFs.

B. The igroup does not contain the. WWPN of one initiator.

C. The fabric name server is disabled.

D. The initiator HBA is not connected to the fabric.

問題#5

An administrator is planning a hardware refresh and data migration from a Data ONTAP 7.3 system to new AFF A3-00 cluster that is using ONTAP 9.0. The Mode system only serves FC LUNs to a Windows 2012Rs server cluster that needs to remain connected after migration Referring to the scenario, which method would be used for the LUN migration.

A. Unified Host Utility Kit

B. 7-Mode Transition Tool (7MIT)

C. Foreign LUN import (FLI)

D. Oncommand system Manager

試験コード: NS0-509問題数量: 89 Q&As更新時間: 2026-10-06

NS0-509フルバージョンを入手

約NS0-509質問

Testpassport

問題#1

問題#2

問題#3

問題#4

問題#5

トップ試験