真実試験のJuniper JN0-681試験問題、練習で知識点を暗記する

下記はJuniper JN0-681試験問題集は実際の試験問題のバージョンの一部です。 JNCIP-DC JN0-681問題集は実際の試験問題バージョンには65問になります。すべての実際の試験問題は、勉強者が最初の試みで成功することを保証できます。JN0-681問題集の実際の試験問題でJuniper試験に不合格になった場合、全額で支払い手数料の払い戻しを受けられます。実際の試験問題をトレーニングしたいでしょうか？では、トレーニングしましょう！

JN0-681フルバージョンを入手

問題#1

Referring to the exhibit, SW-3 and SW-4 have been configured for mixed-mode VCF and added to the VCF. After cabling the new devices into the VCF, you notice that SW-3 automatically joins the VCF, whereas SW-4 does not.

Why are SW-3 and SW-4 behaving this way? (Choose two.)

A. By default, QFX5100 ports are enabled as VCPs.

B. By default, QFX5100 ports are not enabled as VCPs.

C. By default, EX4300 QSPF+ ports are not enabled as VCPs.

D. By default, EX4300 QSFP+ ports are enabled as VCPs.

問題#2

You are configuring VXLAN on a network of QFX5100s, and are using the set vlans vlan100 vxlan command: unreachable-vtep-aging-timer 600
What does this command do?

A. This command ages out a locally learned MAC address assigned to the VTEP after 600 seconds of inactivity.

B. This command ages out the address of the remote VTEP 600 seconds after the last learned MAC address expires.

C. This command ages out all learned MAC addresses assigned to the VTEP after 600 seconds of inactivity.

D. This command ages out a remotely learned VTEP address after 600 seconds of inactivity.

問題#3

Referring to the exhibit, PE1 and PE2 are acting as MPLS Layer 3 VPN PEs to provide the DCI between DC1 and DC2, which are IP Fabrics. Leaf1 and Leaf2 are QFX5100 Series devices acting as VXLAN Layer 2 Gateways using EVPN signaling for the same VXLAN segment.

Which statement is correct about the Edge1 device in this scenario?

A. Edge1's routing table must contain an IP route to both Leaf1 and Leaf2.

B. Edge1 must be configured for BGP labeled unicast on its PE1-facing interface.

C. Edge1 must be configured for MP-BGP using L3VPN signaling.

D. Edge1 must be configured for MP-BGP using EVPN signaling.

問題#4

Which two statements are true regarding IP fabrics?

A. An IP fabric uses standby links for redundancy.

B. An IP fabric uses routing protocols to avoid loops.

C. An IP fabric load balances across links for redundancy.

D. An IP fabric uses Spanning Tree Protocol to avoid loops.

問題#5

You are performing an in-service software upgrade (ISSU) on an QFX5100 Series device.
Which two statements are correct in this scenario? (Choose two.)

A. The vccpd process is used to synchronize the state of the master RE to the new backup R

B. The mgd process is used to validate system configuration requirements.

C. The ksyncd process is used to synchronize the state of the master RE to the new backup R

D. The dcd process is used to validate system configuration requirements.

試験コード: JN0-681問題数量: 65 Q&As更新時間: 2021-04-02

JN0-681フルバージョンを入手

約JN0-681質問

Testpassport

問題#1

問題#2

問題#3

問題#4

問題#5

トップ試験