真実試験のCisco 200-125試験問題、練習で知識点を暗記する

下記はCisco 200-125試験問題集は実際の試験問題のバージョンの一部です。 CCNA Routing and Switching 200-125問題集は実際の試験問題バージョンには759問になります。すべての実際の試験問題は、勉強者が最初の試みで成功することを保証できます。200-125問題集の実際の試験問題でCisco試験に不合格になった場合、全額で支払い手数料の払い戻しを受けられます。実際の試験問題をトレーニングしたいでしょうか？では、トレーニングしましょう！

200-125フルバージョンを入手

問題#1

A network administrator is troubleshooting the OSPF configuration of routers R1 and R2. The routers cannot establish an adjacency relationship on their common Ethernet link. The graphic shows the output of the show ip ospf interface e0 command for routers R1 and R2.
Based on the information in the graphic, what is the cause of this problem?

A. The OSPF area is not configured properly.

B. The priority on R1 should be set higher.

C. The cost on R1 should be set higher.

D. The hello and dead timers are not configured properly.

E. A backup designated router needs to be added to the network.

F. The OSPF process ID numbers must match.

問題#2

Refer to the exhibit.

The two connected ports on the switch are not turning orange or green.
What would be the most effective steps to troubleshoot this physical layer problem? (Choose three.)

A. Ensure that the Ethernet encapsulations match on the interconnected router and switch ports.

B. Ensure that cables A and B are straight-through cables.

C. Ensure cable A is plugged into a trunk port.

D. Ensure the switch has power.

E. Reboot all of the devices.

F. Reseat all cables.

問題#3

Which layer 2 protocol encapsulation type supports synchronous and asynchronous circuis and has built-in security mechanisms?

A. Frame Relay

B. HDLC

C. x.25

D. PPP

問題#4

A network administrator needs to configure a serial link between the main office and a remote location. The router at the remote office is a non-cisco router.
How should the network administrator configure the serial interface of the main office router to make the connection?

A. Main (config)#interface serial 0/0 Main (config-if)#ip address 172.16.1.1 255.255.255.252 Main (config-if)#no shut

B. Main (config)#interface serial 0/0 Main (config-if)#ip address 172.16.1.1 255.255.255.252 Main (config-if)#encapsulation ietf Main (config-if)#no shut

C. Main (config)#interface serial 0/0 Main (config-if)#ip address 172.16.1.1 255.255.255.252 Main (config-if)#encapsulation frame-relay Main (config-if)#authenication chap Main (config-if)#no shut

D. Main (config)#interface serial 0/0 Main (config-if)#ip address 172.16.1.1 255.255.255.252 Main (config-if)#encapsulation ppp Main (config-if)#no shut

問題#5

Two routers named Atlanta and Brevard are connected via their serial interfaces as illustrated, but they are unable to communicate. The Atlanta router is known to have the correct configuration.

Given the partial configurations, identify the fault on the Brevard router that is causing the lack of connectivity.

A. incompatible IP address

B. insufficient bandwidth

C. incorrect subnet mask

D. incompatible encapsulation

E. link reliability too low

F. IPCP closed

試験コード: 200-125問題数量: 759 Q&As更新時間: 2026-11-05

200-125フルバージョンを入手

約200-125質問

Testpassport

問題#1

問題#2

問題#3

問題#4

問題#5

トップ試験